Soft Top Installation

Remove the two bolts and nuts from the black metal U-brackets.

Fit the Soft Top around the lip of bucket without any bolts. line up the U-bracket right on top of the middle BUMP (see photo).

Mark the hole of U-bracket on your bucket, check it twice and check it again!  **If you do make the hole in the wrong spot, just drill a new one. A few extra ventilation holes won't make any difference.

Remove soft top and make a 5mm hole  on your mark.

Loop the black straps around the U-Brackets.

Insert the U-brackets into the Gray Soft Top Pockets .

Install Soft Top and bolt it on with the nut on the outside of the bucket.

Happy Riding!

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.